Please send us a copy of fwstart.log to
support@foxweb.com. Did you have a chance to check the TempDir issue with the procedure I described in my previous message?
FoxWeb Support Team
support@foxweb.com email |
Sent by Roger Stanley on 11/20/2002 06:47:19 AM:
Just looked at the fwstart.log. It says Restarting Channel 1 a ton of times (every second). There is nothing in the error log. Any other suggestions?
Thanks
Sent by FoxWeb Support on 10/24/2002 10:54:42 PM:
There are a couple of possible causes for this behavior. First of all check the file fwstart.log and the FoxWeb Error Log for clues. You should also make sure that the TempDir registry entry hkey_local_machine\software\Aegis Group\FoxWeb\CurrentVersion\TempDir points to a location, in which the FoxWeb user has write privileges.
FoxWeb Support Team
support@foxweb.com email |
Sent by Roger Stanley on 10/24/2002 02:32:49 PM:
I've been using 1.29c for quite some time and upgraded a while back to 2.x. I didn't want to make the change to the new version until I had time to play with it on a different computer (under the "if it ain't broke don't fix it" rule - and the old version never had any problems).
I installed it on a laptop I just purchased so I could test it and when I hit the FWstart it continues to load foxpro (over 78 times last time I ran it) until I'm out of resources (and I have to re-boot the machine).
I'm using VFP 6.0 and Apache if that helps.
I'm sure I messed up somewhere but can't find out where. Any help or hints would be appreciated.